Bluetooth setup

Before you can use your telephone with your vehicle it must be bonded to the vehicle telephone system.

Handling of phones

Up to six Bluetooth devices can be bonded to the vehicle system.

Note: If there is an ongoing call when the phone in use is selected as the new active phone, the call is transferred to the vehicle audio system.

Note: Even if connected to the car system, your phone can still be used in the usual way.

Requirements for Bluetooth connection

The following are required before a Bluetooth phone connection can be made.

1. The Bluetooth feature must be activated on the phone and on the audio unit. Make sure the Bluetooth menu option in the audio unit is set to ON. For information on phone settings, refer to your phone user guide.

2. The private mode must not be activated on the Bluetooth phone.

3. Search for audio device.

4. Select Ford Audio.

5. Enter the code number shown on the vehicle display using the phone keypad. If no code number is shown on the display, enter the Bluetooth PIN number 0000 using the phone keypad. Now enter the Bluetooth PIN number shown on the vehicle display.

Note: A phone call will be disconnected if the audio unit is switched off. If the ignition key is turned to the off position the phone call will remain in progress.

    See also:

    Bonnet release cable - removal and refitting
    Removal 1 Working inside the vehicle, extract the three screws and remove the steering column shroud. Open the bonnet. If the cable is broken, the release latch must be operated using a suitably ...

    Principle of operation
    Electronic stability programme (ESP) without ESP A with ESP B WARNING: ESP does not relieve you of your responsibility to drive with due care and attention. The ESP supports stability when th ...

    Exhaust manifold - removal and refitting
    Note: A new gasket will be required on refitting. Removal 1 Disconnect the battery negative lead. 2 On carburettor and CFI engine models remove the air cleaner as described in the appropriate Pa ...