Telephone setup

Requirements for cradle connection

Your phone must be fitted in a mobile phone holder before it can be used as a cradle phone with your handsfree/voice control system. You will be able to purchase the correct holder for your phone from your dealer.

Placing your phone in the cradle

Note: Your phone must be fitted in a mobile phone holder to allow you to connect the phone to the cradle.

Connect your phone to the cradle.

1. Place the base of the phone in the cradle connection.

Note: Make sure that the phone is pushed fully rearwards in the cradle.

2. Push the phone downwards until a click is heard.

Note: The connection to the system will


Note: The connection to the system will be displayed on your phone.

Phonebook

After start up access to the phonebook can be delayed for up to two minutes.

Phonebook categories

Depending on your phonebook entry, different categories can be displayed in the audio or navigation unit.

For example:

Note: Entries may be displayed without


Note: Entries may be displayed without a category attachment.

The category can also be indicated as an icon:

Phone
Phone

Mobile
Mobile

Home
Home

Office
Office

Fax
Fax

Making a phone an active phone

When using the system for the first time, no phone is connected to the system.

After switching on the ignition the cradle phone and the Bluetooth phone are recognized differently by the system.

Bluetooth phone

After bonding a Bluetooth phone to the system, this becomes the active phone.

For further information refer to the phone menu.

However, in some cases the Bluetooth phone has to be activated by pressing the appropriate station button on the audio or navigation unit.

Turning the ignition back on again, the last active phone is picked up by the system.

Bond another Bluetooth phone

Note: Before another Bluetooth phone can be bonded, the existing active Bluetooth connection has to be deactivated by the mobile phone.

Bond a new Bluetooth phone as described in the requirements for a Bluetooth connection.

Phones stored in the system are accessible by using the phone list on the audio or navigation unit.

Note: If six (five Bluetooth phones for cradle phone system) Bluetooth phones have been bonded, one of these has to be deleted in order to bond a new phone.

Cradle phone

With your phone fitted in the mobile phone cradle this does not automatically become the active phone.

In these cases refer to Changing the active phone in the appropriate section which describes the system fitted to your vehicle.

    See also:

    Fuel quality - Petrol
    Note: We recommend that you use only high quality fuel without additives or other engine treatments. CAUTION: Do not use leaded petrol or petrol with additives containing other metallic compound ...

    Front suspension lower arm inner pivot bush - renewal
    1 To improve access, raise the front of the vehicle on ramps. Apply the handbrake. 2 Unscrew and remove the nut, washer and pivot bolt securing the relevant lower arm to the crossmember. 3 Remove ...

    Fuel level sender unit - removal and refitting
    Caution: Refer to the precautions in Section 1 before proceeding. A new seal must be used when refitting the sender unit. Saloon, Hatchback and Estate models All models except 2.0 litre DOHC 1 ...