Bluetooth setup
Before you can use your telephone with your vehicle it must be bonded to the vehicle telephone system.
Handling of phones
A phone can be connected to the vehicle system by using either a cradle connection or a Bluetooth connection.
On vehicles with a mobile phone cradle, up to five Bluetooth phones can be bonded to the vehicle system.
On vehicles without a mobile phone cradle, up to six Bluetooth phones can be bonded to the vehicle system.
Note: If there is an ongoing call when the phone in use is selected as the new active phone, the call is transferred to the vehicle audio system.
Note: Even if connected to the car system, your phone can still be used in the usual way.
Requirements for Bluetooth connection
The following are required before a Bluetooth phone connection can be made.
1. The Bluetooth feature must be activated on the phone and on the audio unit. For additional information, refer to your phone user guide 2. The private mode must not be activated on the Bluetooth phone.
3. Search for audio device.
4. Select Ford Audio.
5. The Bluetooth PIN number 0000 must be entered on the phone keypad.
Note: A phone call will be disconnected if the audio/navigation system is switched off. If the ignition key is turned to the off position the phone call will remain in progress.
Compatibility of phones
CAUTION:
As no common agreement exists,
mobile phone manufacturers are able
to implement a variety of profiles in
their Bluetooth devices. Because of this,
an incompatibility can occur between the
phone and hands-free system, which in
some cases may significantly degrade the
system performance. To avoid this
situation, only recommended phones
should be used. Please contact your
dealer for more details regarding the
current compatibility list.
Phones with Symbian operating system
Note: Certain phones require a special file to be installed to enable full phonebook access via Bluetooth. This is referred to as a SIS file and will be available via the Ford website. Please consult your dealer for full details.
See also:
Engine - removal leaving automatic transmission in vehicle
Note: A suitable hoist and lifting tackle will be
required for this operation.
1 Proceed as described in Section 8,
paragraphs 1 to 15 inclusive. Additionally, if
applicable disconnect the kickdow ...
Ford Sierra Road Test
Virtually the last of the rear-wheel-drive rep-mobiles, the Sierra was always
a good-handler, compared to many of its contemporary front-drive competitors.
Trouble is, what was a good chassis at t ...
Diagram 3c. Graphic display system - bulb failure. Models from 1987 to May
1989
Diagram 3c. Graphic display system - bulb failure. Models from 1987 to May 1989 ...
