ISOFIX anchor points

WARNING:
Use an anti-rotation device when using the ISOFIX system. We recommend the use of a top tether or support leg.

Your vehicle is fitted with ISOFIX anchor points that accommodate universally approved ISOFIX child restraints.

The ISOFIX system comprises two rigid attachment arms on the child restraint that attach to anchor points on the outboard rear seats, where the cushion and backrest meet. Tether anchor points are fitted behind the outboard rear seats for child restraints with a top tether.

Top tether anchor points



Attaching a child seat with top


Attaching a child seat with top tethers

WARNING:
Do not attach a tether strap to anything other than the correct tether anchor point.

Note: Where applicable, remove the luggage cover to ease installation. See Luggage covers.

Note: On 4-door vehicles, make sure the tether strap tightening mechanism remains accessible when the seatback is fully engaged.

1. Place the child seat on the back seat


1. Place the child seat on the back seat cushion and fold the relevant seatback forwards. See Rear seats.

2. Remove the head restraint. See Head restraints.

WARNING:
Make sure the top tether strap is not slack or twisted and is properly located on the anchor point.

3. Route the tether strap to the anchor point.

WARNING:
Make sure that the seatback is secure and fully engaged in the catch.

4. Push the seatback to the upright position.

5. Push the child seat back firmly to


5. Push the child seat back firmly to engage the ISOFIX lower anchor points.

6. Tighten the tether strap in line with the child seat manufacturer's instructions.

    See also:

    Cylinder head - removal and refitting (engine in vehicle)
    Note: Refer to the warning at the beginning of Section 5 and the note at the beginning of the following Section before proceeding. The cylinder head must not be removed when the engine is warm. R ...

    Pistons and connecting rods - examination and renovation
    1 Examine the pistons for ovality, scoring, and scratches. Check the connecting rods for wear and damage. The connecting rods carry a letter indicating their weight class; all the rods fitted must ...

    Crankshaft rear oil seal - renewal
    1 Remove the flywheel/driveplate and the engine adapter plate. 2 Extract the oil seal using an oil seal removal tool if available. It may also be possible to remove the oil seal by drilling the ou ...