Programming the remote control

You can programme a maximum of eight remote controls to use with your vehicle (including any supplied with your vehicle).

Programming a new remote control

1. Insert the key in the ignition.

2. Cycle the key from position 0 to II and then back to 0 four times in quick succession (about once a second).

3. Remove the key from the ignition and press any button on the remote control.

4. Reinsert the key and turn to position II then 0. Remove the key and test the remote control to confirm programming has been successful.

Reprogramming the unlocking function

Note: When you press the unlock button either all the doors are unlocked or only the driver’s door is unlocked. Pressing the unlock button again unlocks all the doors.

Press and hold the unlock and lock buttons on the remote key simultaneously for at least four seconds with the ignition off. The direction indicators will flash twice to confirm the change.

To return to the original unlocking function, repeat the process.

    See also:

    Hydraulic system - bleeding (conventional braking system)
    Note: On cars equipped with the Anti-lock Braking System, refer to Section 23. Warning: Hydraulic fluid is poisonous; wash off immediately and thoroughly in the case of skin contact, and seek imm ...

    Type approvals
    FCC/INDUSTRY CANADA NOTICE This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) t ...

    Changing a fuse
    WARNINGS: Do not modify the electrical system of your vehicle in any way. Have repairs to the electrical system and the replacement of relays and high current fuses carried out by a properly trai ...