Lighting control

Lighting control positions
Lighting control positions

Off A
Side and tail lamps B
Headlamps C

Parking lamps

CAUTION:
Prolonged use of the parking lamps will discharge the battery.

Switch off the ignition.

Both sides

Set the lighting control to position B.

One side
One side

Right-hand side A
Left-hand side B

Main and dipped beam
Main and dipped beam

Pull the lever fully towards the steering wheel to switch between main and dipped beam.

Headlamp flasher

Pull the lever slightly towards the steering wheel.

Home safe lighting

Switch the ignition off and pull the direction indicator lever towards the steering wheel to switch the headlamps on. You will hear a short tone. The headlamps will go off automatically after three minutes with any door open, or 30 seconds after the last door has been closed.

With all doors closed, but within the 30 second delay, opening any door will result in the three minute timer starting again.

The home safe lights can be cancelled by either pulling the direction indicator lever towards the steering wheel again or by turning the ignition switch on.

    See also:

    Telephone setup
    Requirements for cradle connection Your phone must be fitted in a mobile phone holder before it can be used as a cradle phone with your handsfree/voice control system. You will be able to purcha ...

    Idle speed control valve - removal and refitting
    Note: A new gasket must be used when refitting the valve. 2.0 litre SOHC models 1 Disconnect the battery negative lead. 2 Disconnect the idle speed control valve wiring plug by releasing the reta ...

    Child seat positioning
    Child seat positions WARNINGS: When using a child seat with a seat belt, make sure that the seat belt is not slack or twisted. When you are using a child seat with a support leg, remove the stor ...