Trip computer

Odometer

Registers the total mileage of the vehicle.

Tripmeter

Registers the mileage of individual journeys.

Distance to empty

Indicates the approximate distance the vehicle will travel on the fuel remaining in the tank. Changes in driving pattern may cause the value to vary.

Average fuel consumption

Indicates the average fuel consumption since the function was last reset.

Average speed

Indicates the average speed calculated since the function was last reset.

Outside air temperature

Shows the outside air temperature.

Type 1 and 2
Type 1 and 2

A. Trip computer
B. Odometer
C. Tripmeter

The trip computer includes the following information displays:

Press the up and down arrow buttons


Press the up and down arrow buttons on the steering wheel to scroll through the trip computer displays.

Note: The position of the trip computer display may vary depending on the information shown in the display.

Resetting the trip computer using the main menu

To reset a particular display: 1. Press the right arrow button on the steering wheel to enter the main menu.

2. Highlight Reset Trip with the up and down arrow buttons and press the right arrow button.

3. Highlight the function to be reset.

4. Press the right arrow button to select the function.

5. Hold the OK button pressed.

To reset all three displays, select All values and hold the OK button pressed.

Type 3
Type 3

Trip computer A

Press the OK button on the steering wheel to cycle through the different trip computer displays. To reset a value, press and hold the OK button.

Resetting the trip computer using the main menu

To reset a particular display: 1. Highlight Trip Computer with the up and down arrow buttons and press the right arrow button.

2. Highlight the function to be reset.

3. Hold the OK button pressed.

    See also:

    Gauges
    Tachometer A Information display B Speedometer C Fuel gauge D Tripmeter reset button E Fuel gauge The arrow adjacent to the fuel pump symbol indicates on which side of the vehicle the fuel f ...

    Brake and clutch fluid check
    WARNINGS: Do not allow the fluid to touch your skin or eyes. If this happens, rinse the affected areas immediately with plenty of water and contact your doctor. If the level is at the MIN mark, h ...

    Thermostat - testing
    1 To test the thermostat, suspend it by a piece of string in a container of water (see illustration). 8.1 Testing the thermostat opening temperature 2 Gradually heat the water, and using a ther ...