Keyless starting

WARNINGS:
The keyless starting system may not function if the key is close to metal objects or electronic devices such as mobile phones.

Always check that the steering wheel lock is deactivated before attempting to move your vehicle.

See Steering wheel lock.

Note: A valid passive key must be located inside the vehicle to switch the ignition on and start the engine.

Note: To start your engine you must also fully depress the brake or clutch pedal, depending on the transmission fitted.

Ignition on
Ignition on

Press the start button once. All electrical circuits are operational, warning lamps and indicators illuminate.

Starting with automatic transmission

Note: Releasing the brake pedal during engine start will stop the engine cranking and return to ignition on.

1. Make sure the transmission is in P or N.

2. Fully depress the brake pedal.

3. Press the start button.

Starting with manual transmission

Note: Releasing the clutch pedal during engine start will stop the engine cranking and return to ignition on.

1. Fully depress the clutch pedal.

2. Press the start button.

Starting a diesel engine

Note: Engine cranking may not commence until the engine glow plug cycle has been completed. This may take several seconds in extremely cold conditions.

Note: Continue to press the clutch or brake pedal until engine cranking begins.

Failure to start

The passive starting system will not function if:
• The passive key frequencies are jammed.

• The passive key battery is flat.

If you are unable to start your vehicle carry out the following procedure.

Type
Type

1. Hold the key next to the steering column shroud exactly as shown.

2. With the key in this position you can use the start button to switch the ignition on and start your vehicle.

Type 2
Type 2

1. Carefully prise out the cover.

2. Insert the key into the key holder.


2. Insert the key into the key holder.

3. With the key in this position you can use the start button to switch the ignition on and start your vehicle.

Stopping the engine

When your vehicle is stationary, press the start button to stop the engine. The ignition, all electrical circuits, warning lamps and indicators will be switched off.

    See also:

    Using the rear view camera
    WARNINGS: The operation of the camera may vary depending on the ambient temperature, vehicle and road conditions. The distances shown in the display may differ from the actual distance. Do not ...

    Fuel level sender unit - removal and refitting
    Caution: Refer to the precautions in Section 1 before proceeding. A new seal must be used when refitting the sender unit. Saloon, Hatchback and Estate models All models except 2.0 litre DOHC 1 ...

    Modulator drivebelt (antilock braking system) - removal and refitting
    Note: Whenever an ABS modulator adjuster bolt is slackened or removed, the bolt threads should be lightly coated with grease to prevent the possibility of bolt seizure. Take care not to contaminat ...