Using cruise control

WARNING:
Do not use cruise control in heavy traffic, on twisty roads or when the road surface is slippery.

Switching cruise control on
Switching cruise control on

Setting a speed
Setting a speed

Press the SET+ switch or the SETswitch to store and maintain your current speed. The cruise control indicator illuminates.

Changing the set speed

WARNING:
When you are going downhill, your speed may increase above the set speed. The system will not apply the brakes. Change down a gear and press the RES switch to assist the system in maintaining the set speed.

Note: If you accelerate by pressing the accelerator pedal, the set speed will not change. When you release the accelerator pedal, you will return to the speed that you previously set.

Press the SET+ switch or the SETswitch to accelerate or decelerate.

Cancelling the set speed
Cancelling the set speed

Press the brake pedal or the CAN switch.

The system will no longer control your speed. The cruise control indicator will go off but the system will retain the speed that you previously set.

Resuming the set speed
Resuming the set speed

Press the RES switch. The cruise control indicator illuminates and the system will attempt to resume the speed that you previously set.

Switching cruise control off
Switching cruise control off

Press the OFF switch. The system will not retain the speed that you previously set.

The cruise control indicator will go off.

    See also:

    Starter motor - removal and refitting
    Removal 1 Disconnect the battery. 2 Working from under the vehicle, disconnect the main starter motor cable and the two wires from the starter solenoid (see illustration). 8.2 Disconnecting th ...

    Rear wheel bearings - renewal
    Saloon, Hatchback and Estate models With rear drum brakes Note: There are two types of bolts used to secure the rear hub carrier to the lower arm (see illustration). 14.1a Alternative types of ...

    Power steering fluid check
    Vehicles with 1.4L Duratec-16V (Sigma) or 1.6L Duratec-16V (Sigma) or 1.6L Duratec-16V Ti- VCT (Sigma) engine The fluid level should come up to the MAX mark when the engine is cold. If it drops b ...