Sliding loadspace floor

WARNING:
Do not slide the loadspace floor rearwards when the vehicle is standing on an incline of 15 degrees or more and facing uphill.

CAUTION:
The maximum permissible weight on the sliding loadspace floor is 200 kilogrammes (441 pounds).

The maximum permissible weight on the end of the sliding loadspace floor when the floor is in the fully extended position (slid outside the luggage compartment) is 120 kilogrammes (265 pounds).

Press the unlocking handle and pull the


Press the unlocking handle and pull the loadspace floor rearwards. It will stop and engage at a midway position.

To slide it out fully, press the unlocking


To slide it out fully, press the unlocking handle again and pull it out until it engages in the end position.

To slide it forwards, press the unlocking handle and push it forwards.

Note: You do not have to exert as much pressure on the unlocking handle if you push the loadspace floor forwards slightly when operating it.

Storage compartment

A storage compartment is located in the floor at the rear of the luggage compartment.

To gain access to the storage compartment, lift up the sliding loadspace floor as follows:


1. Press the unlocking handle and pull


1. Press the unlocking handle and pull the loadspace floor rearwards a short way.

2. Lift up the rear of the floor (1).

3. Push the floor forwards until it engages at the front (2).

4. Release the support leg from the clip on the underside of the floor.

5. Insert the end into the square retainer in the left-hand rail (3).

6. Lift the storage compartment cover using the loop.

To return the loadspace floor to the normal position:
1. Hold the floor with one hand and release the support leg with the other hand.

2. Insert the support leg back into the clip.

3. Lower the floor.

4. Press the unlocking handle and pull the loadspace floor rearwards until it drops into position on the rails.

    See also:

    Autounlock
    The autounlock feature will unlock all the doors when: • the ignition is in the on position, all the doors are closed, and the vehicle has been in motion at a speed greater than 12 mph (20 km/h); ...

    Electronic vacuum regulator (1.8 litre (R6A type) CVH) - removal and refitting
    1 The EVR unit is located on the right-hand side of the engine compartment, near the front of the car. 2 Disconnect the battery negative lead. 3 Disconnect the EVR wiring plug, and detach the two ...

    Coolant refill capacity
    To find out how much fluid your vehicle’s cooling system can hold, refer to Maintenance product specifications and capacities in this chapter. Fill your engine coolant reservoir as outlined previo ...