Luggage covers

WARNING:
Do not place objects on the luggage cover.

Pull out the cover and secure it in the


Pull out the cover and secure it in the retaining points.

Release it from the retaining points and let it roll back into the case. Clip the retaining hook onto the case.

To remove or install the cover, push either


To remove or install the cover, push either end of the case inwards.

    See also:

    Fuel injector ballast resistor (1.6 litre CVH) - removal and refitting
    1 The ballast resistor is located on the righthand side of the engine compartment, and is only fitted to 1.6 litre engines (see illustration). 17.1 Fuel injector ballast resistor location (arrow ...

    Handbrake “on” warning lamp switch - renewal
    1 Disconnect the battery negative lead. 2 Working inside the vehicle, remove the handbrake lever rubber gaiter and/or the centre console, as necessary. 3 Disconnect the wiring connector from the ...

    Cab interior trim panels (P100 models) - removal and refitting
    Side trim panel 1 Remove the rear pillar trim panel. 2 Remove the side trim panel by prising out the four expander pins from the clips, then pulling out the clips and withdrawing the panel. 3 Re ...