Bluetooth setup

Before you can use your telephone with your vehicle it must be bonded to the vehicle telephone system.

Handling of phones

Up to six Bluetooth devices can be bonded to the vehicle system.

Note: If there is an ongoing call when the phone in use is selected as the new active phone, the call is transferred to the vehicle audio system.

Note: Even if connected to the car system, your phone can still be used in the usual way.

Requirements for Bluetooth connection

The following are required before a Bluetooth phone connection can be made.

1. The Bluetooth feature must be activated on the phone and on the audio unit. Make sure the Bluetooth menu option in the audio unit is set to ON. For information on phone settings, refer to your phone user guide.

2. The private mode must not be activated on the Bluetooth phone.

3. Search for audio device.

4. Select Ford Audio.

5. Enter the code number shown on the vehicle display using the phone keypad. If no code number is shown on the display, enter the Bluetooth PIN number 0000 using the phone keypad. Now enter the Bluetooth PIN number shown on the vehicle display.

Note: A phone call will be disconnected if the audio unit is switched off. If the ignition key is turned to the off position the phone call will remain in progress.

    See also:

    Rear suspension lower arm (Saloon and Estate models) - removal and refitting
    Removal 1 Raise the rear of the car and support it on stands (see “Jacking and Vehicle Support”). 2 On cars equipped with the anti-lock braking system, refer to Chapter 9 and remove the load appo ...

    General information
    CAUTIONS: Use only approved wheel and tyre sizes. Using other sizes could damage the vehicle and will make the National Type Approval invalid. If you change the diameter of the tyres from that f ...

    Ignition system component check (Every 24 000 miles (40 000 km) or 2 years)
    1 Before disturbing any part of the ignition system, disconnect the battery negative lead. 2 Identify and clearly mark all HT leads before disconnecting them from the spark plugs. 3 Refer to the a ...