Electromagnetic compatibility

WARNINGS:
Your vehicle has been tested and certified to European legislations relating to electromagnetic compatibility (2004/104/EC). It is your responsibility to ensure that any equipment you have fitted complies with applicable local legislations. Have any equipment fitted by properly trained technicians.

Radio frequency (RF) transmitter equipment (e.g. cellular telephones, amateur radio transmitters etc.) may only be fitted to your vehicle if they comply with the parameters shown in the table below. There are no special provisions or conditions for installations or use.

Do not mount any transceiver, microphones, speakers, or any other item in the deployment path of the airbag system.

Do not fasten antenna cables to original vehicle wiring, fuel pipes and brake pipes.

Keep antenna and power cables at least 100mm from any electronic modules and airbags.


1 Only for GSM/3G cellular phones, with a patch antenna installed inside of


1 Only for GSM/3G cellular phones, with a patch antenna installed inside of the front
windscreen.

Note: After the installation of RF transmitters, check for disturbances from and to all electrical equipment in the vehicle, both in the standby and transmit modes.

Check all electrical equipment: Х with the ignition ON.

Х with the engine running.

Х during a road test at various speeds.

Check that electromagnetic fields generated inside the vehicle cabin by the transmitter installed do not exceed human exposure limits specified in EU directive 2004/40/EC.

    See also:

    Load apportioning valve P100 models) - removal and refitting
    Caution: Refer to the precautions in Section 1. Removal 1 Chock the front wheels, jack up the rear of the vehicle and support on axle stands (see УJacking and Vehicle SupportФ). 2 The load appor ...

    Voice control
    To select or deselect voice control, press the button on the top. For further information See Voice control. ...

    Vacuum servo unit and linkage - removal and refitting
    Removal 1 Refer to Section 12 and remove the master cylinder. 2 On fuel-injection models unclip and lift out the front section of the heater plenum chamber to provide access to the connecting li ...