Child seat positioning

Vehicles with under floor storage

WARNINGS:
When you are using a child seat with a support leg, make sure that you install the foam spacer correctly inside the storage compartment and that you position the cover correctly.

If the foam spacer is damaged or missing, remove the storage compartment cover and extend the leg to the base of the compartment.

All vehicles

WARNING:
When fitting a child seat using the vehicle seat belts make sure the belts are not slack.

CAUTION:
When using a child seat on a rear seat, make sure that the child seat rests tightly against the vehicle seat.

It may be necessary to lift or remove the head restraint. See Head restraints.

Note: When using a child seat on a front seat, it may prove difficult to tighten the lap section of the seat belt without slack remaining. If this is the case, adjust the seatback to the fully upright position and raise the height of the seat. See Seats.

X Not suitable for children in this mass group.X Not suitable for children in this mass group.


X Not suitable for children in this mass group.

U Suitable for universal category child seats approved for use in this mass group.

U¹ Suitable for universal category child seats approved for use in this mass group.

However, we recommend that you secure children in a government approved child seat, in the rear seat.

UF¹ Suitable for universal category forward facing child seats approved for use in this
mass group. However, we recommend that you secure children in a government approved child seat, in the rear seat.

ISOFIX child restraints

X Not suitable for children in this mass group.


X Not suitable for children in this mass group.

IUF Suitable for universal category ISOFIX child restraints approved for use in this mass
group.

IL Suitable for any semi-universal ISOFIX child restraint that is indicated in the child seat
manufacturers vehicle list.

* As defined by ECE-R16.

Note: ** When you are purchasing an ISOFIX restraint, make sure that you know the
correct mass group and ISOFIX size class for the intended seating locations.

Note: ** Make sure that the top tether mechanism does not interfere with the luggage
cover.

    See also:

    Rear suspension angles - general
    The rear wheel toe and camber angles are set in production and do not require checking under normal service conditions. Of the two, only the toe setting can be adjusted, the camber angle being fix ...

    Cooling fan switch - removal and refitting
    On CVH models, the cooling fan switch is located on the right-hand side of the thermostat housing (see illustration). On DOHC models, the switch is located in the end of the thermostat housing. R ...

    Removing a headlamp
    1. Open the bonnet. See Opening and closing the bonnet. 2. Remove the screws. 3. Disconnect the electrical connector. 4. Remove the headlamp. Note: When fitting the headlamp, make sure that ...