Changing the remote control battery
Make sure that you dispose of
old batteries in an
environmentally friendly way.
Seek advice from your local authority regarding recycling.
1. Slide the release slider in the direction of the arrow.
2. Remove the key blade.
3. Twist the screwdriver in the position shown to separate the two halves of the remote control.
CAUTION:
Do not touch the battery contacts or
the printed circuit board with the
screwdriver.
4. Carefully prise out the battery with the screwdriver.
5. Install a new battery (3V CR 2032) with the + facing downwards.
6. Assemble the two halves of the remote control.
7. Install the key blade.
See also:
Boot lid lock (Saloon models) - removal and refitting
Removal
1 With the boot lid raised, remove the lock
barrel retaining clip.
2 Where applicable, disconnect the operating
lever from the central locking solenoid/motor,
then withdraw the lock barre ...
Engine/manual gearbox assembly - removal and separation
Note: Refer to the warning in Section 8 before
proceeding. A suitable hoist and lifting tackle
will be required for this operation.
Removal
1 Proceed as described in Section 9,
paragraphs 1 to 17 ...
Diagram 4a. 2.0 litre DOHC engine EFI fuel injection and
ignition systems. Models from 1990 onwards
Diagram 4a. 2.0 litre DOHC engine EFI fuel injection and ignition systems.
Models from 1990 onwards ...