Global opening and closing

You can also operate the electric windows with the ignition off via the global opening and global closing function.

Note: Global closing will only operate if you have set the memory correctly for each window. See Electric windows.

Global opening
Global opening

To open all the windows, press and hold the unlock button for at least three seconds. Press either the lock or the unlock button again to stop the opening function.

Global closing

WARNING:
Take care when using global closing. In an emergency, press the button on the drivers door handle to stop.

Note: Global closing can be activated using the button on the drivers door handle. Global opening and closing can also be activated using the buttons on the passive key.


To close all the windows, press and hold


To close all the windows, press and hold the button on the drivers door handle for at least two seconds. The anti-trap function is also active during global closing.

    See also:

    Engine/transmission - reconnection and installation
    1 This is a direct reversal of removal and separation from the transmission. Take care not to damage the radiator or front wings during installation. Reconnection 2 Reconnection of the engine and ...

    Storage compartments
    WARNING: Do not drive with any storage compartment lid open. Make sure that you secure the lid before setting off. CAUTION: Do not keep heat-sensitive items and liquids in any storage compartme ...

    Temperature gauge sender removal and refitting
    Removal 1 On SOHC models, the temperature gauge sender is located on the front left-hand side of the cylinder head, just in front of the inlet manifold. On CVH models, the sender is located on th ...