Gauges

Base instrument cluster shown in standard measure. Metric similar.

Optional instrument cluster shown in standard measure. Metric


Optional instrument cluster shown in standard measure. Metric similar.

Speedometer: Indicates the


Speedometer: Indicates the current vehicle speed.

Engine coolant temperature


Engine coolant temperature gauge: Indicates engine coolant temperature. At normal operating temperature, the needle will be in the normal range (between УHФ and УCФ). If it enters the red section, the engine is overheating. Stop the vehicle as soon as safely possible, switch off the engine and let the engine cool.

WARNING: Never remove the coolant reservoir cap while the


engine is running or hot. WARNING: Never remove the coolant reservoir cap while the
engine is running or hot.

Fuel gauge: Indicates approximately how much fuel is left in the fuel tank (when the ignition is in the on position). The fuel gauge may vary slightly when the vehicle is in motion or on a grade.

The FUEL icon and arrow indicates which side of the vehicle the fuel filler door is located.

Refer to Filling the tank in the Maintenance and Specifications chapter for more information.

Tachometer: Indicates the engine


Tachometer: Indicates the engine speed in revolutions per minute.

Driving with your tachometer pointer continuously at the top of the scale may damage the engine.

Odometer: Registers the total miles


Odometer: Registers the total miles (kilometers) of the vehicle.

If equipped with a message center, refer to Message center in this chapter on how to switch the display from Metric to English.

Trip odometer: Registers the miles (kilometers) of individual journeys.

Trip odometer: Registers the miles (kilometers) of individual journeys.


Trip odometer: Registers the miles (kilometers) of individual journeys.

Х Standard instrument cluster:

Press the SELECT/RESET control once to switch from the odometer to the TRIP A feature. Press the control again to select the TRIP B feature. To reset the trip, press and hold the control again until the trip reading resets.

Х Optional instrument cluster:


Х Optional instrument cluster:

See TRIP A/B under Message center in this chapter.

Message center (if equipped)


    See also:

    Checking the wiper blades
    Checking the wiper blades Run the tip of your fingers over the edge of the blade to check for roughness. Clean the wiper blade lips with water applied with a soft sponge. ...

    Principle of operation
    Cruise control allows you to control your speed using the switches on the steering wheel. You can use cruise control when you exceed approximately 30 km/h (20 mph). ...

    Major body damage - repair
    Where serious damage has occurred or large areas need renewal due to neglect, it means that completely new sections or panels will need welding in, and this is best left to professionals. If the d ...