Panel dimmer control

Use to adjust the brightness of the instrument panel and all applicable switches in the vehicle during headlamp and parking lamp operation.

Х Move the control to the full upright position, past detent, to turn on the interior lamps.

Х Rotate to full down position (past detent) to prevent interior lamps from illuminating when the doors are opened.

Note: If the battery is disconnected, discharged, or a new battery is
Note: If the battery is disconnected, discharged, or a new battery is installed, the dimmer switch requires re-calibration. Rotate the dimmer switch from the full dim position to the full dome/on position to reset.

This will ensure that your displays are visible under all lighting conditions.

    See also:

    Power-operated folding roof components - removal and refitting
    Hydraulic rams Removal 1 Remove the rear wheelhouse covers with reference to Section 32. 2 Mark the two hoses connected to the ram as a guide to reassembly, then remove the circlips securing the ...

    Hydraulic unit pump and motor (ABS) - removal and refitting
    Note: New sealing washers must be used on the high pressure fluid hose banjo union, and a new O-ring must be used between the accumulator and the hydraulic unit on refitting. Caution: Refer to the ...

    SecuricodeЩ keyless entry system (if equipped)
    You can use the keyless entry keypad to: Х lock or unlock the doors without using a key, Х activate or deactivate the Autolock and Autounlock feature if equipped Х release the liftgate glass, T ...