Multi-function lever

Windshield wiper: Rotate the end of the control away from you to increase the speed of the wipers; rotate towards you to decrease the speed of the wipers.

Windshield washer: Press the end


Windshield washer: Press the end of the stalk:

Х briefly: causes a single swipe of the wipers without washer fluid.

Х a quick press and hold: the wipers will swipe three times with washer fluid.

Х a long press and hold: the wipers and washer fluid will be activated for up to ten seconds.

Courtesy wipe feature: One extra wipe will occur a few seconds after


Courtesy wipe feature: One extra wipe will occur a few seconds after washing the front window to clear any excess washer fluid remaining on the windshield.

Note: Do not operate the washer when the washer reservoir is empty.

This may cause the washer pump to overheat. Check the washer fluid level frequently. Do not operate the wipers when the windshield is dry.

This may scratch the glass, damage the wiper blades and cause the wiper motor to burn out. Before operating the wiper on a dry windshield, always use the windshield washer. In freezing weather, be sure the wiper blades are not frozen to the windshield before operating the wipers.

See also:

Checking automatic transmission fluid (if equipped)
Refer to your scheduled maintenance information for scheduled intervals for fluid checks and changes. Your transmission does not consume fluid. However, the fluid level should be checked if the tra ...

Accelerator pedal - removal and refitting
The procedure is the same as described in Part A of this Chapter for carburettor models. ...

Cold start valve - removal and refitting
Note: Refer to the precautions at the end of Section 1 before proceeding. K-Jetronic system Removal 1 Disconnect the battery earth lead. 2 Detach the electrical wiring multi-plug from the valve ...