Compass zone adjustment

1. Determine which magnetic zone you are in for your geographic location by referring to the zone map.

2. Turn ignition to the on position.

3. Start the engine.

4. Press the SETUP control to select


4. Press the SETUP control to select the Update Zone function and display the current ZONE XX in the center stack display.

5. Continue to press the RESET


5. Continue to press the RESET control until the correct zone appears in the center stack display.

6. The direction will display after


6. The direction will display after the RESET control is released. The zone is now updated.

Compass calibration adjustment


    See also:

    Audio unit commands
    CD Player You can control playback directly by voice control. Overview The overview below shows the available voice commands. The following lists will give further information about the complet ...

    Alternator - removal and refitting
    Note: Refer to the precautions at the end of Section 1 before proceeding. Removal 1 The operations are similar for all makes of alternator. 2 Disconnect the battery negative terminal, then disco ...

    Fuel vapour separator (models from 1985) - removal and refitting
    Caution: Refer to the precautions in Section 1 before proceeding. Removal 1 On SOHC models, the vapour separator is located on the left-hand side of the engine compartment. On CVH models, the va ...