Compass calibration adjustment

Perform compass calibration in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) and make sure all vehicle doors are shut.

1. Start the vehicle.

2. To calibrate, press and hold the RESET control for approximately ten seconds until CAL appears.

Release the control.

3. Slowly drive the vehicle in a


3. Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until the CAL display changes to the direction value. It may take up to five circles to complete calibration.

4. The compass is now calibrated.

Center console


    See also:

    Heater unit - removal and refitting
    Removal 1 Disconnect the battery negative lead. 2 If the coolant is still hot, release the pressure in the system by slowly unscrewing the expansion tank cap. Place a thick rag over the cap to pr ...

    Ending compact disc playback
    To restore radio reception on all units: • Press the RADIO button. Note: This will not eject the CD; the disc will merely pause at the point where radio reception was restored. To resume CD playb ...

    Hydraulic unit (ABS) - removal and refitting
    Note: A new gasket must be used between the hydraulic unit and the bulkhead on refitting. Caution: Refer to the precautions in Section 1. Removal 1 Disconnect the battery negative lead. 2 Depre ...