Fixed code programming

Note: Do not program the Car2U system with the vehicle in the garage.

Make sure that your key is on and engine off while programming the transmitter.

1. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, paper and a pen or pencil.

2. Open the battery cover and record the switch settings from left to right for all 8 to 12 switches. Use the figure below: When a switch is in the up, on, or + position, circle УL.Ф When a switch is in the middle, neutral, or 0 position, circle УM.Ф When a switch is in the down, off, or Ц position, circle УR.Ф

3. To input these positions into the


3. To input these positions into the Car2U system, simultaneously press all three Car2U system buttons for a few seconds and then release to put the device into programming mode. The indicator lights will blink slowly. Within 2.5 minutes enter your corresponding DIP switch settings from left to right into your Car2U system by pressing and releasing the buttons corresponding to the settings you circled.

4. After inputting switch settings, simultaneously press and release all


4. After inputting switch settings, simultaneously press and release all three Car2U system buttons. The indicator lights will turn on.

5. Press and hold the Car2U system button you would like to use to control the garage door.

Immediately (within 1 second) release the button once the garage door moves. During this time the selected button indicator light will blink slowly. Do not release the button until you see the garage door move. Most garage doors open quickly. You may need to hold the button from 5Ц55 seconds before observing movement of the garage door.

6. The indicator light will (begin to) blink rapidly until programming is


6. The indicator light will (begin to) blink rapidly until programming is complete. If your garage door opener does not operate following these steps, repeat Steps 2 through 6. Otherwise, call the toll-free Car2U help line at 1-866-57Car2U (1-866-572-2728).

After successful programming, you will be able to operate your Car2U system by pressing the button you programmed to activate the opener.

The indicator light above the selected button will turn on to confirm that the Car2U system is responding to the button command.

    See also:

    Ford Escort 1997 review
    A pretty face may or may not have launched a thousand ships, but it'll sure 'nuff sell a bunch of cars. That's an ancient and well-documented fact of the car biz. And that's just w ...

    Alternator - removal and refitting
    Removal 1 Disconnect the battery leads. 2 Disconnect the multi-plug, or disconnect the wires from their terminals on the rear of the alternator, noting their locations (as applicable), then slack ...

    Maintenance - bodywork and underframe
    The general condition of a vehicleТs bodywork is the one thing that significantly affects its value. Maintenance is easy but needs to be regular. Neglect, particularly after minor damage, can lead ...