Create a MyKey

To program MyKey on one of the keys programmed to the vehicle, insert the key that you want to make a MyKey into the ignition. Turn the ignition on. Use the message center buttons to do the following:

1. Press SETUP until PRESS RESET TO CREATE MYKEY is displayed.

2. Press and release the RESET button. HOLD RESET TO CONFIRM MYKEY will be displayed.

3. Press and hold the RESET button for two seconds until MARK THIS AS RESTRICTED is displayed.

4. Wait until KEY RESTRICTED AT NEXT START is displayed.

MyKey is successfully programmed. Make sure you label it so you can distinguish it from the admin keys. Note: To program the optional settings go to Step 2 in the Programming MyKey Optional Settings section. If your vehicle is equipped with remote start, see the Using MyKey with Remote Start Systems section.

Note: The MyKey can be cleared within the same key cycle that it was created, otherwise a standard key (Administrator key) is required to clear the MyKey programming. To clear all MyKeys go to Step 2 in the Clear MyKey section.

    See also:

    Rear coil spring (Saloon, Hatchback and Estate models) - removal and refitting
    Models with rear drum brakes 1 Remove the relevant driveshaft. 2 Unscrew the brake pipe from the brake hose at the bracket on the vehicle underbody. Plug the ends of the pipe and hose to prevent ...

    Connecting an external device
    WARNING: Make sure the external device is securely mounted within the vehicle, and that trailing connections do not obstruct any of the driving controls. External devices may be connected using ...

    Engine compartment overview - 2.0L EcoBoost SCTi (MI4)
    A. Brake and clutch fluid reservoir (right-hand drive). See Brake and clutch fluid check. B. Engine oil filler cap1. See Engine oil check. C. Brake and clutch fluid reservoir (left-hand drive). ...