Autolock

The autolock feature will lock all the doors, liftgate and liftgate window when:

all doors are closed,
the ignition is in the on position, you shift into any gear putting the vehicle in motion, and the vehicle attains a speed greater than 12 mph (20 km/h).

The autolock feature repeats when:

any door is opened then closed while the ignition is in the on position and the vehicle speed is 9 mph (15 km/h) or lower, and the vehicle attains a speed greater than 12 mph (20 km/h).

Deactivating/activating autolock

Your vehicle comes with the autolock feature enabled. There are four methods to enable/disable this feature:

Through your authorized dealer, or Performing the power door lock control procedure, or Performing the keyless entry keypad (if equipped) procedure, or Performing the message center (if equipped) procedure.

Note: The autolock feature can be activated/deactivated independently of the autounlock feature.

Before following the activation or deactivation procedures, make sure that the anti-theft system is not armed, ignition is in the off position, and all vehicle doors, liftgate and liftgate window are closed.

Power door unlock/lock procedure

You must complete Steps 1-5 within 30 seconds or the procedure will have to be repeated. If the procedure needs to be repeated, you must wait 30 seconds.

Note: All doors must be closed and remain closed throughout the configuration process.

1. The ignition must be off to begin sequence.

2. Turn the ignition to the on position.

3. Press the power door unlock control three times.

4. Turn the ignition from the on to


4. Turn the ignition from the on to the off position.

5. Press the power door unlock control three times.

6. Turn the ignition back to the on position. The horn will chirp.

7. Press the unlock control, then press the lock control. The horn will chirp once if autolock was deactivated or twice (one short and one long chirp) if autolock was activated.

8. Turn the ignition to the off position. The horn will chirp once to confirm the procedure is complete.

Keyless entry keypad procedure

1. Turn the ignition to the off position.

2. Close all doors, the liftgate and liftgate window.

3. Enter 5digit entry code 4. Press and hold the 3 4. While holding the 3 4 press the 7 8.

5. Release the 7 8.

6. Release the 3 4.

The user should receive a horn chirp to indicate the system has been disabled or a chirp followed by a honk to indicate the system has been enabled.

Message center procedure (if equipped)

For information on activating/deactivating the autolock feature using the vehicles message center, refer to Message center information in the Instrument cluster chapter.

    See also:

    Hazard warning flashers
    Note: Depending on applicable laws and regulations in the country for which your vehicle was originally built, the hazard warning flashers may flash if you brake heavily. For item location: See ...

    Focus in the Market
    When it's not loaded up with expensive options, the Focus remains a viable if not alluring option in the segment. However, Ford's decision to basically reskin the old Focus rather than ...

    Towing a trailer
    WARNINGS: Do not exceed 100 km/h (62 mph). The rear tyre pressures must be increased by 0.2 bar (3 psi) above specification. See Technical specifications. Do not exceed the maximum gross train ...