Autounlock

The autounlock feature will unlock all the doors when:

the ignition is in the on position, all the doors are closed, and the vehicle has been in motion at a speed greater than 12 mph (20 km/h); the vehicle has then come to a stop and the ignition is turned to the off or accessory position; and the driver door is opened within 10 minutes of the ignition being transitioned to the off or accessory position.

Note: The doors will not autounlock if the vehicle has been electronically locked before the driver door is opened.

Deactivating/activating autounlock

Your vehicle comes with the autounlock feature activated. There are four methods to enable/disable this feature:

Through your authorized dealer, or by using the power door unlock/lock sequence, Performing the keyless entry keypad procedure (if equipped), or Performing the message center (if equipped) procedure.

Note: The autounlock feature can be activated/deactivated independently of the autolock feature.

Power door lock switch autounlock enable/disable procedure

Before starting, ensure the ignition is in the off position and all vehicle doors are closed. You must complete Steps 15 within 30 seconds or the procedure will have to be repeated. If the procedure needs to be repeated, wait a minimum of 30 seconds before beginning again.

1. Place the key in the ignition and turn the ignition to the on position.

2. Press the power door unlock control on the door panel three times.

3. Turn the ignition from the on position to the off position.

4. Press the power door unlock control on the door panel three times.


4. Press the power door unlock control on the door panel three times.

5. Turn the ignition back to the on position. The horn will chirp one time to confirm programming mode has been entered and is active.

6. To enable/disable the autounlock feature, press the lock control, then press the unlock control. The horn will chirp once if autounlock was deactivated or twice (one short and one long chirp) if autounlock was activated.

7. Turn the ignition to the off position. The horn will chirp once to confirm the procedure is complete.

Keyless entry keypad autounlock enable/disable procedure

1. Turn the ignition to the off position.

2. Close all doors.

3. Enter factoryset 5digit entry code.

4. Press and hold the 3 4. While holding the 3 4, press and release the 7 8. While still holding the 3 4, press and release the 7 8 a second time.

5. Release the 3 4.

The user should receive a horn chirp to indicate the system has been disabled or a chirp followed by a honk to indicate the system has been enabled.

Message center procedure (if equipped)

For information on activating/deactivating the autounlock feature using the vehicles message center, refer to Message center information in the Instrument cluster chapter.

    See also:

    Adjusting the headlamps - Vehicles With: Adaptive Front Lighting/Xenon Headlamps
    To adjust the headlamps for driving on the left or right hand side of the road, see your dealer. ...

    Using seat belts during pregnancy
    Using seat belts during pregnancy WARNING: Position the seat belt correctly for your safety and that of your unborn child. Do not use only the lap strap or the shoulder strap. Position the lap ...

    Using voice control
    System operation The order and content of the voice controls are given in the following lists. The tables show the sequence of user voice commands and system responses for each available function ...