Securicode keyless entry system (if equipped)

You can use the keyless entry keypad to:

lock or unlock the doors without using a key, activate or deactivate the Autolock and Autounlock feature if equipped
release the liftgate glass,

The keypad can be operated with the factory set 5digit entry code; this code is located on the owners wallet card in the glove box and is available from your authorized dealer. You can also create your own 5digit personal entry code.

When pressing the controls on the keyless entry keypad, press the middle of the controls to ensure a good activation.

Programming your own personal entry code

To create your own personal entry code:

1. Enter the factory set code.

2. Within five seconds press the 1 2 on the keypad. The doors will lock and then unlock to confirm that the system is in programming mode.

3. Enter your personal 5digit code.


3. Enter your personal 5digit code.

Each number must be entered within five seconds of each other.

4. Press 1 2 on the keypad to assign the Driver 1 setting. The doors will lock and then unlock to confirm that your personal entry code has been programmed.

You can store up to three personal entry codes. The above procedure shows how to set the Driver 1 setting. To assign the additional settings, repeat Steps 1 through 3, then for Step 4, do one of the following:

Press 3 4 to assign the Driver 2 setting.

Press 5 6, 7 8, or 9 0 to assign the Driver 3 setting.

Tips

Do not use five numbers in sequential order.

The factory set code will work even if you have set your own personal code.

Erasing personal code

1. Enter the factory set 5digit code.

2. Within five seconds, press the 1 2 on the keypad and release.

3. Press and hold the 1 2 for two seconds. This must be done within five seconds of completing Step 2.

Your personal code is now erased and only the factory set 5digit code will work.

Anti-scan feature

If the wrong code has been entered seven times (35 consecutive button presses), the keypad will go into an anti-scan mode. This mode disables the keypad for one minute and the keypad lamp will flash.

The anti-scan feature will turn off after:

one minute of keypad inactivity, pressing the remote entry transmitter, control on the
remote entry transmitter, or the ignition position changes.

Unlocking and locking the doors and liftgate using keyless entry

To unlock the drivers door, enter the factory set 5-digit code or your personal code. Each number must be pressed within five seconds of each other. The interior lamps will illuminate.

To unlock all doors and liftgate, press the 3 4 control within five seconds of entering the factory set 5-digit code or your personal code.

To lock all doors and liftgate, press the 7 8 and the 9 0 at the same time. Note: The drivers door must be closed. You do not need to enter the keypad code first.

To open the liftgate glass, press the 5 6 after entering the factory set 5-digit code or your personal code.

    See also:

    Child safety locks
    WARNING: You cannot open the doors from inside if you have put the child safety locks on. Child safety locks Left-hand side Turn anti-clockwise to lock and clockwise to unlock. Right-hand si ...

    Auxiliary warning system components - removal and refitting
    General 1 This system monitors the fluid levels and front brake pads for excessive wear. In the event of a fluid level dropping below the specified level, or the brake pads wearing down to the mi ...

    Distributor lubrication - models with contact breaker distributor (Every 6000 miles or 6 months)
    1 Remove the distributor cap and the rotor arm. 2 Apply a couple of drops of light oil to the felt pad in the top of the shaft. 3 Wipe clean the distributor cam, then apply a trace of high meltin ...