Combination lap and shoulder belts

1. Insert the belt tongue into the proper buckle (the buckle closest to the direction the tongue is coming from) until you hear a snap and feel it latch. Make sure the tongue is securely fastened in the buckle.

2. To unfasten, press the release


2. To unfasten, press the release button and remove the tongue from the buckle.

Restraint of pregnant women


Restraint of pregnant women

and the safety belt properly fastened. The lap portion of the WARNING: Always ride and drive with your seatback upright
and the safety belt properly fastened. The lap portion of the safety belt should fit snug and be positioned low across the hips. The shoulder portion of the safety belt should be positioned across the chest. Pregnant women should also follow this practice. See figure below.

Pregnant women should always wear their safety belt. The lap belt portion of a combination lap and shoulder belt should be positioned low across the hips below the belly and worn as tight as comfort will allow. The shoulder belt should be positioned to cross the middle of the shoulder and the center of the chest.

Energy Management Feature


    See also:

    Rear axle tube (Van models) - removal and refitting
    Removal 1 Raise the rear of the vehicle and support it on stands (see “Jacking and Vehicle Support”). Remove the rear roadwheels. 2 Support the axle tube on a jack preferably of trolley type. 3 ...

    Carburettor (Weber 2V TLD) - fast idle speed adjustment
    1 Proceed as described for the Weber 2V carburettor, noting the following. 2 The fast idle adjustment screw should be positioned on the third (middle) step of the fast idle cam (see illustration). ...

    Engine - refitting (automatic transmission in vehicle)
    1 Reverse the procedure described in Section 10, noting the following points: 2 Check that the engine adapter plate is correctly positioned on its locating dowels. 3 As the torque converter is onl ...