Jump starting

1. Start the engine of the booster vehicle and run the engine at moderately increased speed.

2. Start the engine of the disabled vehicle.

3. Once the disabled vehicle has been started, run both engines for an additional three minutes before disconnecting the jumper cables.

    See also:

    Fluid reservoir (ABS) - removal and refitting
    Note: New seals must be used between the reservoir and the hydraulic unit on reassembly. Caution: Refer to the precautions in Section 1. Removal 1 Disconnect the battery negative lead. 2 Depress ...

    Type approvals
    FCC/INDUSTRY CANADA NOTICE This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) t ...

    Rear suspension and final drive unit assembly (Saloon, Hatchback and Estate models) - removal and refitting
    Note: From May 1986, revised final drive unit rear mounting bolts have been used in production. Whenever the earlier type of bolts are removed, they should be discarded and the later type fitted. ...