Child seat positioning

WARNINGS:
When using a child seat with a support leg, the support leg must rest securely on the floor.

When using a child seat with a seat belt, make sure that the seat belt is not slack or twisted.

CAUTION:
The child seat must rest tightly against the vehicle seat. It may be necessary to lift or remove the head restraint. See Head restraints.

Note: When using a child seat on a front seat, it may prove difficult to tighten the lap section of the seat belt without slack remaining. If this is the case, adjust the seatback to the fully upright position and raise the height of the seat. See Seats.

X Not suitable for children in this mass group.


X

Not suitable for children in this mass group.

U

Suitable for universal category child seats approved for use in this mass group.

Suitable for universal category child seats approved for use in this mass group.

However, we recommend that you secure children in a government approved child seat, in the rear seat.

UF¹

Suitable for universal category forward facing child seats approved for use in this
mass group. However, we recommend that you secure children in a government approved child seat, in the rear seat.

ISOFIX child seats

IUF Suitable for universal category ISOFIX child seats approved for


IUF

Suitable for universal category ISOFIX child seats approved for use in this mass
group.

IL

Suitable for the following ISOFIX child seats: Roemer Duo ISOFIX (group 1), Roemer
Babysafe ISOFIX (group 0+). In addition, any semi-universal ISOFIX child seat may be
used if indicated in the child seat manufacturers vehicle list.

Note: * As defined by ECE-R16.

Note: ** When you are purchasing an ISOFIX seat, make sure that you know the correct
mass group and ISOFIX size class for the intended seating locations.

Note: ** Make sure that the top tether mechanism does not interfere with the luggage
cover.

    See also:

    Changing a fuse
    WARNINGS: Do not modify the electrical system of your vehicle in any way. Have repairs to the electrical system and the replacement of relays and high current fuses carried out by properly traine ...

    Auxiliary power sockets
    CAUTION: If you use the socket when the engine is not running, the battery may discharge. Note: You can use the socket to power 12 volt appliances that have a maximum current rating of 10 Ampere ...

    Fuel injector ballast resistor (1.6 litre CVH) - removal and refitting
    1 The ballast resistor is located on the righthand side of the engine compartment, and is only fitted to 1.6 litre engines (see illustration). 17.1 Fuel injector ballast resistor location (arrow ...