ISOFIX anchor points

WARNING:
Use an anti-rotation device when using the ISOFIX system. We recommend the use of a top tether or support leg.

Your vehicle is fitted with ISOFIX anchor points that accommodate universally approved ISOFIX child seats.

The ISOFIX system comprises of two rigid attachment arms on the child seat that attach to anchor points on the outboard rear seats, where the cushion and backrest meet. Tether anchor points are fitted behind the outboard rear seats for child seats with a top tether.

Top tether anchor points
Top tether anchor points

Attaching a child seat with top tethers

WARNING:
Do not attach a tether strap to anything other than the correct tether anchor point.

Note: Where applicable, remove the luggage cover to ease installation. See Luggage covers.

1. Place the child seat on the back seat


1. Place the child seat on the back seat cushion and fold the relevant seatback forwards. See Rear seats.

2. Remove the head restraint. See Head restraints.

WARNING:
Make sure the top tether strap is not slack or twisted and is properly located on the anchor point.

3. Route the tether strap to the anchor point.

WARNING:
Make sure that the seatback is secure and fully engaged in the catch.

4. Push the seatback to the upright position.

5. Push the child seat back firmly to


5. Push the child seat back firmly to engage the ISOFIX lower anchor points.

6. Tighten the tether strap in line with the child seat manufacturer's instructions.

    See also:

    Coded keys
    Note: Do not shield your keys with metal objects. This may prevent the receiver from recognising your key as a valid one. Note: Have all of your remaining keys erased and recoded if you lose a key ...

    Daytime running lamps (DRL) (if equipped)
    Turns the low beam headlamps on with a reduced output. To activate: Х the ignition must be in the on position. Х the headlamp control must be in the off, parking lamps or autolamp position. Х ...

    Hydraulic unit pump and motor (ABS) - removal and refitting
    Note: New sealing washers must be used on the high pressure fluid hose banjo union, and a new O-ring must be used between the accumulator and the hydraulic unit on refitting. Caution: Refer to the ...