Lighting control

Lighting control positions
Lighting control positions

Off A
Side and tail lamps B
Headlamps C

Parking lamps

CAUTION:
Prolonged use of the parking lamps will discharge the battery.

Switch off the ignition.

Set the lighting control to position B.

Main and dipped beam
Main and dipped beam

Pull the lever fully towards the steering wheel to switch between main and dipped beam.

Headlamp flasher

Pull the lever slightly towards the steering wheel.

Home safe lighting

Switch the ignition off and pull the direction indicator lever towards the steering wheel to switch the headlamps on. You will hear a short tone. The headlamps will go off automatically after three minutes with any door open, or 30 seconds after the last door has been closed.

With all doors closed, but within the 30 second delay, opening any door will result in the three minute timer starting again.

The home safe lights can be cancelled by either pulling the direction indicator lever towards the steering wheel again or by turning the ignition switch on.

    See also:

    Crankshaft and main bearings - removal and refitting
    Note: A new crankshaft rear oil seal and a new rear oil seal housing gasket should be used on refitting. Removal 1 With the engine removed from the vehicle, remove the timing chain and crankshaft ...

    Sitting in the correct position
    Sitting in the correct position WARNINGS: Do not adjust the seats when the vehicle is moving. Only when you use the seat belt properly, can it hold you in a position that allows the airbag to ...

    Valve clearance adjustment - OHV and HCS engines (Every 12 000 miles or 12 months)
    OHV engines 1 This operation should be carried out with the engine cold and the air cleaner and rocker cover removed. 2 Using a ring spanner or socket on the crankshaft pulley bolt, turn the cran ...