Electric windows

WARNING:
Do not operate the electric windows unless they are free from obstruction.

Note: If you operate the switches often during a short period of time, the system might become inoperable for a certain time to prevent damage due to overheating.

Switch on the ignition to operate the electric windows.

Driver's door switches

You can operate all the windows with the switches on the door trim panel of the drivers door.

Opening and closing the


Opening and closing the driver's window automatically

Press or lift the switch to the second action point and release it completely.

Press or lift it again to stop the window.

Safety switch for rear windows

Note: You can always operate the rear windows from the drivers door.

A switch in the drivers door disables the


A switch in the drivers door disables the rear electric window switches.

The light in the switch comes on and the lights in the rear window switches go off when the rear windows are disabled.

Anti-trap function

WARNING:
Careless closing of the window can override the protection function and cause injuries.

Note: The anti-trap function is only available on the driver's window.

The electric window will stop automatically while closing and reverse some distance if there is an obstacle in the way.

Overriding the anti-trap function

CAUTION:
While you close the window for the third time, the anti-trap function is disabled. Make sure there are no obstacles in the way of the closing window.

To override this protection function when there is a resistance, e.g. in the winter, proceed as follows:
1. Close the window twice until it reaches the resistance and let it reverse.

2. Close the window a third time to the resistance. The anti-trap function is disabled and you cannot close the window automatically. The window will override the resistance and you can close it fully.

3. If the window does not close after the third attempt, have it checked by a properly trained technician.

Resetting the memory of the electric window

WARNING:
The anti-trap function is deactivated until you have reset the memory.

After the battery has been disconnected from the vehicle you must reset the memory for the driver's window: 1. Lift the switch until the window is fully closed. Hold the switch lifted for one more second.

2. Release the switch and lift it again, two or three times, for one more second.

3. Open the window and try to close it automatically.

4. Reset and repeat procedure if the window does not close automatically.

    See also:

    Central Fuel Injection (CFI) unit - removal and refitting
    Note: Refer to the precautions at the end of Section 1 before proceeding. Removal 1 Disconnect the battery negative lead. 2 Remove the air cleaner assembly. 3 Depressurise the fuel system as desc ...

    ISOFIX anchor points
    ISOFIX anchor points You can fit ISOFIX child restraints using the ISOFIX anchor points. Your vehicle is fitted with ISOFIX anchor points that accommodate universally approved ISOFIX child rest ...

    Brake pedal - removal, refitting and adjustment
    Removal 1 Working within the vehicle, remove the under-dash cover panel. 2 Extract the spring clip which connects the pushrod to the arm of the brake pedal. 3 Extract the circlip from the end of ...