General information

WARNINGS:
Use load securing straps to an approved standard, e.g. DIN.

Make sure that you secure all loose items properly.

Place luggage and other loads as low and as far forward as possible within the luggage or loadspace.

Do not drive with the tailgate or rear door open. Exhaust fumes may enter the vehicle.

Do not exceed the maximum front and rear axle loads for your vehicle.

See Vehicle identification.

CAUTIONS:
Do not allow items to contact the rear windows.

Do not use any abrasive materials to clean the interior of the rear windows.

Do not install stickers or labels to the interior of the rear windows.

    See also:

    Cylinder block and bores - examination and renovation
    1 The cylinder bores must be examined for taper, ovality, scoring and scratches. Start by examining the top of the bores; if these are worn, a slight ridge will be found which marks the top of the ...

    Wash/wipe system components - removal and refitting
    Windscreen washer pump Engine compartment-mounted reservoir Removal 1 Drain the washer fluid container. 2 Disconnect the lead and washer pipe. 3 Ease the top of the washer pump away from the fl ...

    Alternator drivebelt check (Every 6000 miles or 6 months)
    1 A conventional vee drivebelt is used to drive both the alternators and water pump pulleys on OHV and HCS engines, and the alternator pulley only on CVH engines, power being transmitted via a pul ...