Engine coolant check

Checking the coolant level

WARNING:
Do not allow the fluid to touch your skin or eyes. If this happens, rinse the affected areas immediately with plenty of water and contact your doctor.

CAUTION:
Make sure that the level is between the MIN and the MAX marks.

Note: Coolant expands when it is hot.

The level may therefore extend beyond the MAX mark.

If the level is at the MIN mark, top up immediately.

Topping up

WARNINGS:
Only top up when the engine is cold.

If the engine is hot, wait 10 minutes for the engine to cool down.

Do not remove the filler cap when the engine is running.

Do not remove the filler cap when the engine is hot. Wait for the engine to cool down.

Unscrew the cap slowly

. Any pressure will escape slowly as you unscrew the cap.

CAUTIONS:
Do not spill coolant on any part of the engine.

Do not top up further than the MAX mark.

Top up with fluid that meets the Ford specification. See Technical specifications.

    See also:

    Personalised settings
    1. Use the rotary to enter the main menu. 2. Press the SET/RESET button to choose a sub-menu and adjust the settings. ESP Select this option to activate or deactivate ESP. 1. Use the rotary co ...

    Engine dismantling, examination, renovation and reassembly - general information
    Dismantling 1 Refer to Chapter 2, Part A, Section 18, paragraphs 1 to 8 inclusive. 2 A suitable selection of splined and Torx sockets will be required to remove many of the bolts when dismantling ...

    Principle of operation
    WARNING: The parking aid does not relieve you of your responsibility to drive with due care and attention. CAUTIONS: Vehicles fitted with a trailer tow module not approved by us may not correct ...