Station tuning control

Seek tuning

Select a waveband and briefly press one of the seek buttons. The unit will stop at the first station it finds in the direction you have chosen.

Manual tuning

Type 1

Х Press the MENU button.

Х Select RADIO mode and then MANUAL TUNE.

Х Press one of the arrows to tune down or up the waveband in small increments or press and hold to increment quickly, until you find a station you want to listen to.

Х Press OK to continue listening to a station.

Type 2

Х Press function button 2.

Х Then press one of the arrows to tune down or up the waveband in small increments or press and hold to increment quickly, until you find a station you want to listen to.

Х Press OK to continue listening to a station.

Scan tuning

SCAN allows you to listen to a few seconds of each station detected.

Type 1

Х Press the MENU button.

Х Select RADIO mode and then SCAN.

Х Use the arrow buttons to scan up or down the selected waveband.

Х Press OK to continue listening to a station.

Type 2

Х Press function button 3.

Х Use the seek buttons to scan up or down the selected waveband.

Х Press function button 3 again, to continue listening to a station.

    See also:

    General information
    WARNINGS: Use load securing straps to an approved standard, e.g. DIN. Make sure that you secure all loose items properly. Place luggage and other loads as low and as far forward as possible wit ...

    Electronic vacuum regulator (1.8 litre (R6A type) CVH) - removal and refitting
    1 The EVR unit is located on the right-hand side of the engine compartment, near the front of the car. 2 Disconnect the battery negative lead. 3 Disconnect the EVR wiring plug, and detach the two ...

    Diagram 2: 1980-86 Lighting all models
    Diagram 2: 1980-86 Lighting all models ...