Bluetooth setup

Before you can use your telephone with your vehicle it must be bonded to the vehicle telephone system.

Handling of phones

Up to six Bluetooth devices can be bonded to the vehicle system.

Note: If there is an ongoing call when the phone in use is selected as the new active phone, the call is transferred to the vehicle audio system.

Note: Even if connected to the car system, your phone can still be used in the usual way.

Requirements for Bluetooth connection

The following are required before a Bluetooth phone connection can be made.

1. The Bluetooth feature must be activated on the phone and on the audio unit. Make sure the Bluetooth menu option in the audio unit is set to ON. For information on phone settings, refer to your phone user guide.

2. The private mode must not be activated on the Bluetooth phone.

3. Search for audio device.

4. Select Ford Audio.

5. Enter the code number shown on the vehicle display using the phone keypad. If no code number is shown on the display, enter the Bluetooth PIN number 0000 using the phone keypad. Now enter the Bluetooth PIN number shown on the vehicle display.

Note: A phone call will be disconnected if the audio unit is switched off. If the ignition key is turned to the off position the phone call will remain in progress.

    See also:

    Engine compartment overview - 1.6L Duratec-16V Ti-VCT (Sigma)
    A. Engine coolant reservoir*: See Engine coolant check. B. Brake and clutch fluid reservoir (right-hand drive)*: See Brake and clutch fluid check C. Engine oil filler cap*: See Engine oil check. ...

    Spark control system components (carburettor models) - removal and refitting
    Spark delay and sustain valves 1 Disconnect the vacuum pipes at the valve and withdraw the valve. 2 When refitting a spark delay valve, the valve must be positioned with the black end (marked “CA ...

    Engine/manual gearbox assembly - reconnection and refitting
    1 Reverse the procedure described in Section 11, noting the following points. 2 Before attempting to reconnect the engine to the gearbox, check that the clutch friction disc is centralised. This i ...