Changing the remote control battery

Make sure that you dispose of


Make sure that you dispose of old batteries in an
environmentally friendly way.

Seek advice from your local authority regarding recycling.

Remote control with a folding key blade
Remote control with a folding key blade

1. Insert a screwdriver as far as possible into the slot on the side of the remote control, push it towards the key blade and remove the key blade.

2. Twist the screwdriver in the position


2. Twist the screwdriver in the position shown to start separating the two halves of the remote control.

3. Twist the screwdriver in the position


3. Twist the screwdriver in the position shown to separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

4. Carefully prise out the battery with the screwdriver.

5. Install a new battery (3V CR 2032) with the + facing downwards.

6. Assemble the two halves of the remote control.

7. Install the key blade.

Remote control without a folding key blade

Type 1
Type 1

1. Insert a screwdriver into the recess on the back of the key and remove the key blade.

2. Release the retaining clips with the screwdriver and separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

3. Carefully prise out the battery with the screwdriver.

4. Install a new battery (3V CR 2032) with the + facing upwards.

5. Assemble the two halves of the remote control.

6. Install the key blade.

Type 2
Type 2

1. Slide the release slider in the direction of the arrow.

2. Remove the key blade.

3. Twist the screwdriver in the position


3. Twist the screwdriver in the position shown to separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

4. Carefully prise out the battery with the screwdriver.

5. Install a new battery (3V CR 2032) with the + facing downwards.

6. Assemble the two halves of the remote control.

7. Install the key blade.

    See also:

    Using hill start assist
    The system can operate in either automatic or manual mode. If you select automatic mode, the system is activated automatically when the vehicle is on a slope and you press the brake pedal. If you ...

    Changing the wiper blades
    Windscreen wiper blades CAUTIONS: Set the windscreen wipers in the service position to change the wiper blades. You can use the service position in winter to provide easier access to the wiper ...

    Heater controls - removal and refitting
    Pre-1986 models Removal 1 Working inside the vehicle, remove the dash lower trim panel from the right-hand side. The panel is secured by two metal tags and two clips. 2 Detach the air ducts from ...