Global opening and closing

You can also operate the electric windows with the ignition off via the global opening and global closing function.

Note: Global closing will only operate if you have set the memory correctly for each window. See Electric windows.

Global opening
Global opening

To open all the windows, press and hold the unlock button for at least three seconds. Press either the lock or the unlock button again to stop the opening function.

Global closing

Vehicles without keyless entry
Vehicles without keyless entry

WARNING:
Take care when using global closing. In an emergency, press a button immediately to stop.

To close all the windows, press and hold the lock button for at least three seconds. Press any button again to stop the closing function. The anti-trap function is also active during global closing.

Vehicles with keyless entry
Vehicles with keyless entry

WARNING:
Take care when using global closing. In an emergency, press the button on the drivers door handle to stop.

Note: Global closing can be activated using the button on the drivers door handle. Global opening and closing can also be activated using the buttons on the passive key.

To close all the windows, press and hold the button on the drivers door handle for at least two seconds. The anti-trap function is also active during global closing.

    See also:

    Exhaust system check (Every 6000 miles (10 000 km) or 6 months)
    With the vehicle raised on a hoist or supported on axle stands, check the exhaust system for signs of leaks, corrosion or damage and check the rubber mountings for condition and security. Where da ...

    Telephone commands
    Phone Your phone system allows you to create an additional phonebook. The stored entries can be dialled by voice control. Phone numbers stored by using voice control are stored on the vehicle sys ...

    Examination and renovation
    1 Clean all components using paraffin and a stiff brush, except the crankshaft, which should be wiped clean and the oil passages cleaned out with a length of wire. 2 Never assume that a component ...