Temperature gauge sender unit - removal and refitting
Note: Suitable jointing compound will be required on refitting.
Removal
1 With the engine cold unscrew the pressure
cap on the thermostat housing or expansion
tank as applicable, then refit it. This will
release any residual pressure in the system
and minimise coolant loss when the sender
unit is removed.
2 Disconnect the wiring and unscrew the sender unit located on the forward facing side of the cylinder head, below the thermostat housing on OHV engines, or adjacent to the thermostat housing on CVH engines (see illustrations).
7.2a Temperature gauge sender unit location in cylinder head - OHV engines
7.2b Temperature gauge sender unit location in cylinder head - CVH engines
Refitting 3 To refit, smear the threads of the sender unit with jointing compound and screw it into the cylinder head securely.
4 Reconnect the wiring and top-up the cooling system as described in Chapter 1.
See also:
Specifications
General
System type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . Multi-point electronic fuel injection
Application . . . . . . . . . . . . . . . . . ...
Boot lid lock (Saloon models) - removal and refitting
Removal
1 With the boot lid raised, remove the lock
barrel retaining clip.
2 Where applicable, disconnect the operating
lever from the central locking solenoid/motor,
then withdraw the lock barre ...
Speed control (if equipped)
With speed control set, you can maintain a speed of 48 km/h (30 mph)
or more without keeping your foot on the pedal. Speed control does not
work at speeds below 48 km/h (30 mph).
Do not use the spe ...