Heater motor/fan - removal and refitting
Removal
1 Open the bonnet, disconnect the battery
and pull off the rubber seal which seals the air
inlet duct to the bonnet lid when the lid is
closed.
2 Prise off the five spring clips from the plenum chamber cover and detach the cover at the front.
3 Disconnect the wiring harness multi-plug, and the earth lead at its body connection adjacent to the heater pipe stub cover plate on the engine compartment bulkhead.
4 Unscrew and remove the fan housing mounting nuts and lift the housing from the engine compartment (see illustration).
13.4 Heater motor/fan assembly - viewed with cover removed
5 Insert the blade of a screwdriver and prise off the securing clips so that the fan covers can be removed (see illustration).
13.5 Prising off a heater fan cover clip
6 Remove the resistor and lift out the motor/fan assembly.
Refitting
7 Reassembly and refitting are reversals of
dismantling and removal.
See also:
Central Fuel Injection (CFI) unit - removal and refitting
Note: Refer to the precautions at the end of
Section 1 before proceeding.
Removal
1 Disconnect the battery negative lead.
2 Remove the air cleaner assembly.
3 Depressurise the fuel system as desc ...
ESC II system components - removal and refitting
Note: Procedures for removal and refitting of
the ignition system components and
electronic module are given elsewhere in the
relevant Sections of this Chapter.
1 Disconnect the battery negative l ...
Pistons and connecting rods - examination and renovation
1 Examine the pistons for ovality, scoring,
and scratches. Check the connecting rods for
wear and damage. The connecting rods carry
a letter indicating their weight class; all the
rods fitted must ...