Accelerator pedal - removal and refitting
Removal
1 The pedal can be removed once the throttle
cable has been disconnected from it as
described in Section 7.
2 Undo the two pedal support bracket retaining bolts and remove the pedal.
Refitting
3 Refitting is the reversal of removal but on
completion check the throttle cable
adjustment as described in Section 7.
See also:
Crankshaft and main bearings - removal and refitting
1.8 litre (R2A type)
Removal
1 With the engine removed from the vehicle,
remove the timing belt, crankshaft sprocket
and thrustwasher.
2 Remove the pistons and connecting rods. If
no work is to ...
Cylinder head - removal and refitting
Removal
Note: On HCS engines, cylinder head bolts
may be used a total of three times (including
initial fit) and must be suitably marked to
indicate each removal operation. A new
cylinder head ga ...
Camshaft - removal and refitting
Carburettor engines
Note: Thread locking compound will be
required to coat the camshaft sprocket bolt on
refitting.
Removal
1 Disconnect the battery negative lead.
2 Refer to the relevant Part o ...