Auxiliary air device - removal and refitting
K-Jetronic system
Removal
1 Disconnect the battery earth lead.
2 Disconnect the wiring multi-plug and the two air hoses from the device which is located beneath the cold start valve (see illustration).
10.2 K-Jetronic system auxiliary air device connections
A Throttle housing hose
B Cold start valve hose
C Wiring multi-plug
3 Undo the two Torx type retaining bolts using a Torx key or socket bit and lift the unit away (see illustration).
10.3 K-Jetronic system auxiliary air device retaining bolt locations
Refitting 4 Refitting is a reversal of removal.
KE-Jetronic system
Removal
5 Apply the handbrake, jack up the front of
the car and support it on axle stands (see
“Jacking and Vehicle Support”).
6 Disconnect the battery negative lead.
7 Disconnect the auxiliary air device wiring multi-plug and the two air hoses.
8 Undo the two Torx type retaining bolts using a Torx key or socket bit and remove the unit from under the inlet manifold (see illustration).
10.8 KE-Jetronic system auxiliary air device retaining bolts
Refitting 9 Refitting is a reversal of removal.
See also:
Exhaust manifold nut check - RS Turbo models (Every 6000 miles
or 6 months)
Check the tightness of the exhaust
manifold securing nuts using a torque wrench. ...
Steering wheel - removal and refitting
Removal
1 According to model, either pull off the
steering wheel trim, prise out the insert which
carries the Ford motif at the centre, or carefully
prise up and lift off the horn push followed by ...
Front disc caliper - removal, overhaul and refitting
Caution: Refer to the
precautions in Section 1.
Removal
1 Apply the handbrake, loosen the relevant
roadwheel nuts, then jack up the front of the
vehicle and support on axle stands. (see
“Jacking ...