Fuel pressure regulator - removal and refitting
Note: Refer to the precautions at the end of Section 1 before proceeding.
Removal
1 The fuel pressure regulator is only used on
KE-Jetronic systems and is located behind
the fuel distributor (see illustration).
13.1 KE-Jetronic fuel pressure regulator location (arrowed) behind fuel
distributor
2 Disconnect the battery negative lead.
3 Relieve the system pressure by slowly loosening the cold start valve union on the top of the fuel distributor (see illustration 6.4).
Absorb fuel leakage in a cloth.
4 Place absorbent cloth beneath the regulator and undo the two fuel feed unions and the fuel return union. Note the pipe locations to ensure correct refitting.
5 Remove the securing tie and withdraw the regulator from its bracket.
Refitting
6 Refitting is a reversal of removal. Ensure
that all unions are correctly reconnected and
secure, and on completion check for fuel leaks
with the engine running (see illustration).
13.6 KE-Jetronic fuel pressure regulator pipe connections
A Fuel feed B Fuel return
5 Remove the securing tie and withdraw the regulator from its bracket.
Refitting
6 Refitting is a reversal of removal. Ensure
that all unions are correctly reconnected and
secure, and on completion check for fuel leaks
with the engine running (see illustration).
See also:
Horn - removal and refitting
Removal
1 The horn(s) are located in the left-hand front
corner of the engine compartment. Before
removing, disconnect the battery.
2 Disconnect the lead from the horn.
3 Unscrew the single bolt ...
Steering wheel - centralising
1 This operation is for correcting small errors
in steering wheel centralisation - up to 60º.
For larger errors, remove the steering wheel
and make a rough correction by repositioning
the whe ...
Routine maintenance and servicing
Ford Sierra maintenance schedule
The maintenance intervals in this manual
are provided with the assumption that you will
be carrying out the work yourself. These are
the minimum maintenance interv ...