Electro-magnetic pressure actuator - removal and refitting
Note: Refer to the precautions at the end of Section 1 before proceeding. New O-rings must be used on refitting.
Removal
1 The electro-magnetic pressure actuator is
only used on KE-Jetronic systems and is
located on the side of the fuel distributor.
2 Disconnect the battery negative lead.
3 Remove the air cleaner as described in Section 2.
4 Relieve the system pressure by slowly loosening the cold start valve union on the top of the fuel distributor (see illustration 6.4).
Absorb fuel leakage in a cloth.
5 Disconnect the wiring multi-plug, then undo the two screws securing the actuator to the fuel distributor (see illustration). Remove the unit and the sealing O-rings.
15.5 Pressure actuator wiring multi-plug (arrowed)
Refitting 6 Refitting is the reverse sequence to removal, but ensure both mating faces are clean. New O-rings must be used and care taken not to displace them when fitting. On completion check for fuel leaks with the engine running.
See also:
Fuel and exhaust systems - carburettor
General information and precautions
General information
The fuel system on carburettor models
may comprise a fuel tank, a fuel pump, a fuel
pressure regulator and/or vapour separator, a
downdraug ...
CVH engines
CVH (Compound Valve angle, Hemispherical combustion chambers)
engines are of four cylinder in-line overhead camshaft type, mounted
transversely, together with the transmission, at the front of the ...
Minor body damage - repair
Note: For more detailed information about
bodywork repair, Haynes Publishing produce
a book by Lindsay Porter called ”The Car
Bodywork Repair Manual”. This incorporates
information on such aspects ...