Throttle Position Sensor (TPS) - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Unclip and disconnect the sensor wiring plug.
3 Remove the two securing screws, and withdraw the sensor from the throttle valve shaft (see illustration).
11.3 Throttle position sensor (TPS) location (arrowed) on side of CFI unit
Refitting 4 Refitting is a reversal of removal, but ensure that the sensor actuating arm is correctly located.
See also:
Driveshaft check (Every 12 000 miles or 12 months)
1 Carry out a thorough inspection of the
driveshafts and joints as follows.
2 Jack up the front of the car and support it
securely on axle stands (see “Jacking and
Vehicle Support”).
3 Slowly rot ...
Heater controls - adjustment
1 On heaters with lever control, set both
control levers approximately 2.0 mm up from
their lowest setting. On heaters with rotary
controls set the controls just off the COLD
and CLOSED positions. ...
Oil pump - removal and refitting
Note: A new gasket must be used on refitting.
Removal
1 The oil pump is externally mounted on the
rear facing side of the crankcase.
2 Using a strap wrench or similar, unscrew and
remove the oil ...