Throttle valve control motor - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Remove the air cleaner assembly.
3 Disconnect the wiring plugs from the motor and the throttle position sensor.
4 Remove the screws securing the motor and throttle position sensor assembly mounting bracket to the CFI unit, and withdraw the assembly.
5 Remove the motor securing screws and withdraw the motor from the bracket.
Refitting
6 Refitting is a reversal of removal, bearing in
mind the following points.
7 Ensure that the throttle position sensor locates correctly on the throttle valve spindle, and that the mounting bracket aligns with its locating pegs.
8 On completion, the idle speed should be checked by a Ford dealer at the earliest opportunity.
See also:
Ford Escort Service and Repair Manual
Routine maintenance and servicin
...
Fuel injectors - removal and refitting
Caution: Refer to the
precautions in Section 1 before
proceeding.
Note: A tachometer and an exhaust gas
analyser will be required to check the idle
mixture on completion. New seals and
retaining ...
Engine Coolant Temperature (ECT) sensor - removal and refitting
Removal
1 The sensor is screwed into the cylinder
block below the inlet manifold.
2 Disconnect the battery negative lead.
3 Drain the cooling system as described in
Chapter 1.
4 Disconnect the s ...