Air Charge Temperature (ACT) sensor - removal and refitting
Removal
1 The ACT sensor is screwed into the CFI
unit.
2 Disconnect the battery negative lead.
3 Remove the air cleaner assembly.
4 Disconnect the ACT sensor wiring plug (see illustration).
13.4 Disconnecting the ACT sensor wiring plug - 1.4 CFI engine
5 Unscrew the sensor from the CFI unit.
Refitting
6 Refitting is a reversal of removal.
See also:
General information and precautions
General information
The system is best described by dividing it
into four separate sub-systems: air, fuel,
engine management (EEC IV system), and
ignition.
Air system
The air system consists of ...
Piston/connecting rod assemblies - removal and refitting
Note: A piston ring compressor tool will be
required for this operation.
Removal
1 Remove the cylinder head and the sump as
described in Sections 4 and 5 respectively. Do
not remove the oil pick- ...
Fuel-injection control module - removal and refitting
Removal
1 The fuel-injection control module is only
used on KE-Jetronic systems and is located in
the engine compartment behind the heater
plenum chamber and fan motor.
2 Disconnect the battery n ...