Engine Coolant Temperature (ECT) sensor - removal and refitting
Removal
1 The ECT sensor is screwed into the inlet
manifold.
2 Disconnect the battery negative lead.
3 Partially drain the cooling system as described in Chapter 1.
4 Disconnect the sensor wiring plug.
5 Unscrew the sensor from the inlet manifold.
Refitting
6 Refitting is a reversal of removal, but on
completion top-up the cooling system as
described in “Weekly checks”.
See also:
Fuses and relays - location and renewal
Location
1 The main fuses and relays are located in a
box in the engine compartment on the righthand
side of the bulkhead. The circuits
protected are identified by symbols on the
underside of the ...
Brake disc - examination, removal and refitting
Note: From 1987, thicker brake discs were
fitted. If the later discs are fitted to earlier
models, longer wheel studs must be fitted to
accommodate the increased thickness.
Consult a dealer for fu ...
Exterior lamp bulbs - renewal
Note: The glass envelopes of the headlamp,
auxiliary driving lamp and front foglamp bulbs
must not be touched with the fingers. If the
glass is accidentally touched, it should be
washed with methy ...