Knock sensor - removal and refitting
Removal
1 The knock sensor is screwed into the
cylinder block, near the oil filter (see
illustration).
15.1 Knock sensor location - 1.4 CFI engine
A Knock sensor
B Wiring plug
C Securing bolt
2 Disconnect the battery negative lead.
3 Disconnect the sensor wiring plug by depressing the plug locking lugs and pulling the plug from the sensor. Do not pull on the wiring.
4 Unscrew the securing bolt and withdraw the sensor from the cylinder block.
Refitting
5 Refitting is a reversal of removal, but ensure
that the mating faces of the sensor and
cylinder block are clean.
See also:
Cylinder head - removal and refitting (engine removed)
Note: Up to early 1984, splined type cylinder
head bolts were used, and from early 1984,
size T55 Torx bolts were used. Torx type bolts
must always be renewed after slackening. The
two types of bo ...
Ford VV carburettor manual choke unit - removal, checking and
refitting
Note: A new gasket will be required on
refitting.
Removal
1 Disconnect the battery negative lead.
2 Remove the air cleaner (Section 2).
3 Slacken the choke cable clamp bolt at the
choke lever, d ...
Fuel pump - testing, removal and refitting
Note: Refer to the warning at the end of
Section 1 before proceeding.
Testing
1 The fuel pump may be quite simply tested
by disconnecting the fuel inlet pipe from the
carburettor and placing its ...