EEC IV module - removal and refitting
Removal
1 The EEC IV module is located behind the
centre console, beneath the trim panel (see
illustration).
20.1 EEC IV module location (arrowed) 1.4 CFI engine
2 Disconnect the battery negative lead.
3 Remove the trim panel to expose the module, then pull the module from its bracket behind the centre console.
4 Loosen the screw securing the wiring plug, then disconnect the plug and withdraw the module.
Refitting
5 Refitting is a reversal of removal.
See also:
Inlet manifold - removal and refitting
SOHC models
Removal
1 Disconnect the battery negative lead.
2 Partially drain the cooling system.
3 Remove the air cleaner.
4 Disconnect the coolant hoses from the
automatic choke (where applica ...
Engine Coolant Temperature (ECT) sensor - removal and refitting
Removal
1 The sensor is screwed into the cylinder
block below the inlet manifold.
2 Disconnect the battery negative lead.
3 Drain the cooling system as described in
Chapter 1.
4 Disconnect the s ...
Rear brake shoes - renewal
Warning: Brake shoes must be
renewed on both rear wheels at
the same time - never renew the
shoes on only one wheel, as
uneven braking may result. Also, the dust
created by wear of the shoes may ...